Automatic Capping Machine with Lid Feeder Leafypack

TECHNICAL SPECS
 
· Conveyor belt size: 100 x 100 mm
· Belt height from floor: 950 ± 50 mm
· Chain width: 82.5 mm 
· Structure of the machine made of SS 304, positioned on adjustable feet in height, built in high resistant material.
· Safety protections stop the machine should a problem occur on the stars preventing bottles from breaking and machine damaging.
· Stainless steel electrical panel placed at machine side with ‘auxiliaries’ commands at 24 volts.
· Electronic controls of the machine via PLC touch screen.
· All devices in charge with transfer and movement of the bottles are realised in HD polyethylene to ensure the minimum wear and a fully silent functioning.
· Complete with entry sensor for automatic start and exit sensor for “too many bottles” accident
· Machine supplied with one set of tools for working one product format and “one cap” format.

PLC & ELECTRICAL CABINET
 
Stainless steel electric board with low voltage controls, placed at machine side. Complete with electrical photocells placed in the enter and on the exit, in the case of problems and no arrival of bottles, the machine stops. Machine speed electronically adjusted by means of inverter. The Machine is complete with stainless steel electric board with low voltage controls, placed at machine frame side. Electronic control of the machine by a SIEMENS PLC touch screen. (Allen-Bradley or other brands available on demand).

PRELIMINARY / INDICATIVE Voltage
400 Volt 3PH + N + T
Frequency
50 Hz
Auxiliary
24V
Power consumption
7.5 kW
Air consumption
950 Lt. / Min at 14.5 PSI

· Suitable to close PLASTIC / GLASS bottles with pre-threaded caps.
· Automatic machine complete with cap sorter placed on independent frame with manual height adjustment.
· Horizontal cap transport with photocells.
 
PICK & PLACE Divide
 
· Closing head built in SS 304
· The closing head installed on the capper is a hysteresis closing head with continuous torque. The hysteresis technology offers transmission without contact and therefore without wear. The hysteresis capping heads ensure high accuracy of repetition of the torque (± 2%) and with their continuous closing torque (no impact), are therefore the optimal choice for the application of plastic pre-threaded screw caps, better suited than conventional magnetic heads with permanent magnet and with intermittent torque. The capping head limit torque can be adjusted up to 3.4 Nm. SS 304 heads provide excellent corrosion resistance and wear.

• Electronic control of the electro valves by means of an encoder, adjustable by the PLC.
• Electrical adjustment of the speed by inverter.
• Manual height adjustment.
• 1 M of conveyor at machine inlet.
• 1 M of conveyor at machine outlet.
• Conveyor belt motorization.