Co2 PPM Controller - The Protector

Details

This controller utilizes a built-in photocell feature to limit CO2 production to light hours, maximizing savings and increasing yields. It features three control modes:

1. PPM UP for CO2 generator use
2. FUZZY LOGIC for superior accuracy with a tank and regulator setup
3. PPM DOWN if desired

It is ETL, CE, and FCC-approved for safety and dependability.

SPECIFICATIONS:

• Max Amp: 14.5 amps @ 120 VAC / 60Hz
• Sensor Cord Length: 15 ft / 4.5 m
• CO2 Control Range (PPM): 400-5000
• CO2 Accuracy (PPM): +/-50
• Weight: 2.1 lbs / 1 kg
• Dimensions: 5.07 x 4.68 x 1.95 in / 130 x 120 x 50 mm
• Indoor use only
• Altitude: up to 6500 ft / 2000 m
• Operating Temperature Range: 40-105°F / 4-40°C
• Maximum Relative Humidity: 80>#/span###
• IP Rating: IP20

FACTORY SETTINGS:

• CO2 PPM Set Point: 1000 PPM
• CO2 Deadband Set Point: 50 PPM
• CO2 Calibration Set Point: 400 PPM
• CO2 Mode: PPM UP

Accessories included:

• Wall/Tent Mounting Hardware

Sold separately:

• 24V Power Adapter

Warnings:

• Follow the directions for the installation
• Save instructions
• Heed all warnings
• The output voltages of this controller's receptacles are the same as the input voltage
• Do not use this controller near a water source
• Do not attempt to repair
• Stop using the product if there is any sign of damage to the power cable insulation
• Do not block any ventilation openings
• This product is a Safety Class I Controller